Hudson-robotics SoftLinx 5.0 Uživatelský manuál stáhnout pdf (Strana 41)

This will replace the source plate when necessary.

The target plates are handled in a similar manner, although additional steps must be taken when preparing

new target plates and storing finished target plates. The steps are as follows:

- Check the target plate. If it is not ready to be removed, do nothing.

- If the plate is ready to be removed, move the finished target plate to the plate sealer.

- Begin sealing the plate. While sealing the plate, move a new target plate to the micro 10, if there are still

source plates that can fill the remaining target plates.

- Remove the finished target plate from the plate sealer, and place in a finished targets stack.

- Remove the newly filled target plate from the Micro 10, and move it to the target nest of the Rapid Pick.

As these steps have a few decisions to be made, place steps down, one at a time. Start with a conditional

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 49 50

Žádné komentáře

Hudson-robotics SoftLinx 5.0 Uživatelský manuál Strana 41